As time increases, the surface of the ABS probe will be dirty

Although the surface of the ABS sensor probe is almost all covered by metal，But when actual use，It is a more delicate thing。Since its position is close to the bearings，seabet ioTime a long，It is easy to be soiled by all kinds of dust and butter in the bearings、Even rust，Let it fill the dirt with the wheel gear，Affects magnetic induction detection effect。

The dirty probe can no longer see it

In many years of maintenance experience，Many ABS sensor failure cases are caused by too much bearing butter，Excessive butter is easily squeezed into the probe when installing the wheel。Light affects ABS probe sensitivity，Direction directly leads to the unsight barrel of the probe，Let the ABS system fail。

This situation is slightly better

Whether it is a bridge sensor bracket，Still handmade welding installation method，This situation is very common，butter plus dust and the metal debris dropped by the brake pads，All accumulated to the surface of the probe。

Use butter to evenly apply after cleaning，Prevent rust to death in the band -japer

The prevention and processing method of this situation is very simple，That is not too much when applying butter，A moderate amount。When cleaning, you only need to remove the probe from the bracket，Wash thoroughly，Then apply a layer of butter evenly between it and the band，Prevent the situation where rust dies in the bracket in the future。

Completed cleaning

After seabet loginthe cleaning is completed，insert ABS probe completely into the bracket，Be sure to push to the end，With the correct wheel installation method，You can restore it to normal work。

Disappearing Garma covered by butter covered by butter

In addition to ABS sensor probes，The gear on the wheel hub also needs to be cleaned regularly，Detectives and gear gears need to be kept clean。Of course，When cleaning, we must first check whether the sensor probe cable is intact，If the cable breaks，So no matter how clean it is, it has no effect，Can only replace the probe。

● Editorial saying:

In fact, the method of cleaning up ABS sensor probes and gear gears is very simple，and it is not as trouble as we think，As long as the ABS system work is normal，We just need to pay attention to the degree of cleaning their cleaning。This can make the ABS system always monitor the running state of the wheels accurately。