Brake pad，Also known as "brake shoe" or "brake pad"，Although it is small，But for the last few meters，Brake pads are also the most basic and important wearing parts in the active safety system。Because brake pads are consumables，Will gradually wear out with use，Must be replaced when worn to the extreme position，Otherwise the braking effect will be seabet loginreduced，Even cause security risks。

Brake pads are generally inspected every 5,000 kilometers，If it is found that the friction block wears less than 1 mm, it needs to be replaced。(Generally, replace it every 30,000-40,000 kilometers)。And new brake pads also need to go through a certain running-in period，In order to effectively maximize its braking effect。

Brake pads and discs will wear out after a period of use，When wear reaches the limit，Needs to be replaced。After replacing new brake pads，The contact surface between the brake pad and the brake disc failed to achieve optimal contact，Affects braking performance，The so-called "unstoppable" situation will occur。Therefore，New brake pads need to be broken in，Increase the contact area between the brake pad and the brake disc，Better braking effect。

Normally，New brake pads need to be broken in for 200 kilometers to achieve the best braking effect，Therefore，Suggestion，Vehicles that have just had new brake pads must be driven with caution。Under normal driving conditions，The brake pads should be inspected every 5000 kilometers。

1.After completing the installation，Find a place with good road conditions and few cars to start running in。

2. Accelerate the car to 100 km/h.

3.Lightly apply the brakes and brake with medium force to slow the vehicle down to about 10-20 km/h。

4.Release the seabet iobrakes and drive a few kilometers to use the brake pads、Cool the tablet temperature slightly。

5. Repeat steps 2-4 above at least 10 times.

1.During braking from 100 to 10-20km/h each time，It is not strictly required to have a very accurate speed every time，You can start this braking cycle by accelerating to about 100km/h。

2.When you brake to 10-20km/h，There is no need to keep an eye on the speedometer，Just keep your eyes on the road，Make sure to pay attention to road safety，Approximately every braking cycle，Just brake to about 10-20km/h。

3.The ten braking cycles are in progress，Cannot brake until the vehicle stops，Unless you want the pad material to be integrated into the disc，Thus causing brake vibration;

4.The running-in method of new brake pads is to use divided braking as much as possible，Don’t use the emergency brake before running in。

5.After running in, the brake pads still need to go through a running-in period of several hundred kilometers with the brake disc to achieve optimal performance，Be sure to drive carefully at this time，Prevent accidents。