brake pad，Also known as "brake hoof" or "brake skin"，Although the volume is small，But for the distance of the last few meters，Bad pads are also the most basic and important and damaged parts in the active safety system。Because the brake pads are consumables，Gradually wear in use，You must be replaced when you wear it to the limit position，Otherwise, the effect of braking will be reduced，Even causes seabet loginhidden safety hazards。

Both brake pads are generally checked every 5,000 kilometers，If you find that the friction block loss is less than 1 mm, you need to replace it。(Generally speaking 3-40,000 kilometers, replace it once)。And the newly replaced brake pads also need to go through a certain running -in period，Only to effectively play its brake effect。

The brake pads and brake discs will wear wear after a period of use，When we wear to reach the limit，Need to replace it for it。After changing to a new brake pad，The contact surface of the brake pads and the brake disc did not reach the best contact，Affects braking performance，The so -called "unable to brake" the situation that will appear。So，You need to run in for a new brake pad，Increase the contact area between the brake pads and the brake disc，Be better as the braking effect。

Usually，The new brake pads need to run into 200 kilometers to achieve the best braking effect，So，Suggestion，Vehicles that just change new brake pads must drive carefully。Under normal driving conditions，Check the brake pads 5000 kilometers per driving。

1. After completing the installation，Find a place with little road conditions and start running in。

2. Accelerate the car to 100 kilometers per hour.

3. Step on the brakes with medium force braking seabet appto reduce the speed to about 10-20 km/h。

4. Remove the brakes for a few kilometers to make the brake pads、The temperature of the film is slightly cooled。

5. Repeat the above steps 2-4 at least 10 times.

1. In a brake from 100 to 10-20km/h each time，Unscrupulous requires a very accurate speed every time，Accelerate to about 100km/h to start this brake cycle。

2. When you brake to 10-20km/h，There is no need to pay attention to the speed table，Just keep your eyes to look at the road，Make sure to pay attention to road safety，About the brake cycle every time，Shattering to almost 10-20km/h。

3. This ten brake cycle performed，Can't brake the vehicle to stop，Unless you want to merge the brake pad material into the brake disc，leading to brake vibration;

4. The running -in method of the new brake pads is to use the points to brake as much as possible，Do not use the emergency brakes before it is not ground。

5. The brake pads after the running -in still need to be the best performance with the brake disc，Be sure to drive carefully at this time，Prevent accidents。