I believe many friends are curious，Can the engine be rinsed with water，Some people say that they can，Some people say it can't，So can it? Let's analyze it together today ~

The engine can be said to be a highly precise mechanical part，and there are pads between each equipment，sealed ring, etc.，Instruments that cannot even flow out of oil，Is it possible to penetrate water?

Of course impossible，Unless your engine seal has become a big problem。However，Hitter，Breaking the machine!

As long as it is a good engine，I will not penetrate it，But water is still likely to enter the engine compartment，Why?

Possibly, becauseThere are two ports of the engine, an exit, an entrance, which is what we often sayInlet and exhaust. And water is from here to the engine!

seabet myMany cars are different according to the engine layout，There are also different arrangements for air intake，But the exhaust is mostly unified，Hanging at the tail。and the engine will enter the water after ignition after the water is turned off，Not the water where the airport is in，Instead, water inlet caused by the inverted exhaust mouth。

Let's take a look at the intake port of several typical engines ▼

As can be seen from these pictures,The air inlet of the engine will have certain protective devices.It is to ensure that the water will not enter the air intake so easily，SoAs long as you do not use water guns to spray water in the air intake，I will not enter the air inlet。

So can you rinse it casually?Of course not, the flushing engine compartment is still skillful!

Consequences: Destruction circuit

Because there are various lines in the engine compartment，Electronic components，For example, motor，Fund Box，If the water pressure is too high，A slightly damaged route will cause the circuit to be short -circuit，Light -burning fuse，Those with heavy burning the entire circuit board。

Consequences: cylinder burst

After the car runs at a high or long -term use，The temperature of the engine will be very high。And now it is the summer time，Temperature is not a problem with fried eggs casually，Rinse with water at this time，Due to thermal expansion and contraction, the engine cylinder is prone to burstThis is a trivial matter, just change the engine directly!

Many car owners are confused why the new car is foggy after washing the car，You can clearly see water vapor，This is with everyone when washing the car，Rinse the headlights with high pressure water guns。

Even if it is a vacuum headlight, it will definitely leaveXiaohong for ventilation，The calories used to exude headlights。Under the pressure of high -pressure water guns，still some water will be "pressed" into the lampshade，Very difficult to remove it!

If you modify the headlights of the car，Don't rinse the headlights。Pry the original car headlight assembly，Then change it to various highlight headlights，The sealing of headlights is often greatly discounted。So，The owner should try not to clean the headlight assembly position with water，Be sure to pay attention not to splash water on the modified headlights when washing the engine compartment，To avoid the lamps from entering the water into a "goldfish tank"。

Last，The engine cabin is washed，Owish odor has also been cleaned，We only needDry the water of the engine compartment with a towel, and then start the engine，Use the heat of the engine to "steam the dry" engine compartment water! So，The engine can not be cleaned，Instead of cleaning，Are you get here? (Photo is derived from the Internet，If you involve the copyright, please contact delete)