There are two main aspects of the maintenance of the vehicle，First is a compulsory maintenance provided by the franchise store。On the other hand, some daily maintenance made by the owner himself。The normal maintenance of the vehicle is related to the life of the vehicle and your safety。If it is maintained or used properly, it will cause vehicle failure，Bringing hidden safety hazards。So you except you go to our franchise store for compulsory maintenance，You should also do your daily maintenance work，This is good for the vehicle's & quot; health & quot;。 
a, Check the engine oil volume 
Parking the vehicle on a horizontal road。Pull out the cursor ruler to check the amount of oil，Oil Liang Ruo Ruo ( f) and (L) are within two standard lines，It belongs to the normal range，If it is lower than (L) bit。The specified model should be added，The liquid surface after refueling cannot be higher than ( f) bit. 
Seabet2. The engine coolant surface inspection 
When the engine is in the heat machine,，Do not open the radiator cover，Otherwise, the coolant or high -temperature vapor burns that may be splashed out。After the engine is cooled，Checking the liquid surface of the coolant should be between full and low，Otherwise, you should add distilled water or pure water (you cannot add mineral water) or freezing liquid，The height of the liquid surface after adding water cannot exceed the full bit。If the coolant decreases quickly in a short period of time，Should check whether the cooling system has leaked or go to a specialty store to check。 
3, Checking of the brake liquid surface 
The braking is also high、Between the low position indicates normal。If the brake fluid is close to the lower limit or lower than the lower limit, it means that there may be leakage or brake hoof wear in the system，Should be maintained at the maintenance station in time。 When adding the brake fluid，Pay attention to adding the same type of brake solution，Prevent damage to the leather bowl，Pay attention to protect the paint to prevent corrosion and paint。 
Four, Check of the clutch total pump liquid surface 
Platter liquid surface is high、Low liquid surface means normal，If lower than the standard line，​​It may be the damage of the total pump or split pump leather bowl。The phenomenon that is difficult or unable to hang the gear when the engine is running，Please go to the nearest maintenance station for maintenance。 
Five, Maintenance inspection of batteries 
Check whether the battery fixation is firm，The electrolyte should be between the upper limit and the lower seabet applimit，When you are close to the offline, you should replenish the electrolyte or distilled water to the high -level line。Keep the battery positive and negative cables well in contact，and keep the battery clean and dry。Vehicles with a longer placement time need to remove the positive and negative polar cable of the battery，Re -wiring the engine for about 20 minutes after about half a month apart，If the battery is obviously insufficient, charge it in time。 
6. Tire check 
Tire pressure should be checked at room temperature every month，If lower than normal standards, you should replenish tire pressure in time。The air pressure cannot be too high or too low，Otherwise, it will affect the safety of driving。 Check the cracking of the tire，Tires should be replaced in time when there are hidden safety hazards。When choosing tires，It should be consistent with the model。 
Seven, Check of the air filter 
Excessive air filter is dirty, which will cause engine work bad、too much fuel consumption，Damage engine, etc.，When checking the air filter，If you find that there is less dust，The blocked is lighter，Available high -pressure air can be blown from the inside out，Continue to use。Over -dirty air filter should be replaced in time。 
eight, Checking of Spark plugs 
Normal spark plug insulation ceramics intact。No rupture leakage phenomenon，Spark plug gap 0.8 -0.0mm discharge，Spark is blue，Stronger。If abnormalities are found, you need to adjust the gap or replace the spark plug。 
Nine, Check the gasoline filter 
If the oil supply is not smooth, check whether the gasoline filter is blocked，If a foreign body is blocked, replace it in time。